--- /dev/null
+OVERVIEW
+============================================================
+This example will wait for a Mifare Ultralight card to enter
+the RF field, and then try to dump the card's contents to
+USB CDC.
+
+HOW TO USE THIS EXAMPLE
+============================================================
+1.) Connect the PN532 NFC Breakout Board to UART on the
+ LPC1343 as follows:
+
+ PN532 LPC1343
+ ----- -------
+ GND GND
+ TXD RXD
+ RXD TXD
+ 3.3V 3.3V
+
+ Set SEL0 to Off and SEL1 to Off (= UART)
+
+ or via I2C as follows:
+
+ PN532 LPC1343
+ ----- -------
+ GND GND
+ SDA SDA
+ SCL SCL
+ IRQ 3.2
+ 3.3V 3.3V
+
+ Set SEL0 to On and SEL1 to Off (= I2C)
+
+2.) Configure your terminal software to open the USB COM
+ port at 115K.
+
+3.) When the application starts, there is a 5 second delay
+ (to allow you time to connect via USB CDC), after which
+ point the device will wait for a single ISO14443A card
+ (Mifare Classic, etc.) and try to read it's ID. Once a
+ card is found, the reader will start looking again for a
+ card after a 1 second delay.
+
+SAMPLE OUTPUT
+============================================================
+
+When a Mifare Ultralight card is placed in the field you
+should see results similar to the following:
+
+ Please insert a Mifare Ultralight card
+ UID: 04 7b cb 51 96 22 80
+
+ Page Hex Text
+ ---- -------- ----
+ 0x00 047bcb3c .{Ë<
+ 0x01 51962280 Q\96"\80
+ 0x02 6548ff7f eHÿ
+ 0x03 e1100600 á...
+ 0x04 031dd101 ..Ñ.
+ 0x05 19550174 .U.t
+ 0x06 7461672e tag.
+ 0x07 62652f6d be/m
+ 0x08 2f303437 /047
+ 0x09 42434235 BCB5
+ 0x0a 31393632 1962
+ 0x0b 32383050 280P
+ 0x0c c7badbbb Ǻۻ
+ 0x0d 3df622c1 =ö"Á
+ 0x0e 68e88f24 hè\8f$
+ 0x0f 00000000 ....