+int __devinit r6040_init_one(struct pci_dev *pdev,
+ const struct pci_device_id *ent)
+{
+ struct net_device *dev;
+ struct r6040_private *lp;
+ void __iomem *ioaddr;
+ int err, io_size = R6040_IO_SIZE;
+ static int card_idx = -1;
+ int bar = 0;
+ long pioaddr;
+
+ printk(KERN_INFO "%s\n", version);
+ printk(KERN_INFO DRV_NAME ": debug %x\n", debug);
+
+ err = pci_enable_device(pdev);
+ if (err)
+ return err;
+
+ /* this should always be supported */
+ if (pci_set_dma_mask(pdev, DMA_32BIT_MASK)) {
+ printk(KERN_ERR DRV_NAME "32-bit PCI DMA addresses"
+ "not supported by the card\n");
+ return -ENODEV;
+ }
+ if (pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK)) {
+ printk(KERN_ERR DRV_NAME "32-bit PCI DMA addresses"
+ "not supported by the card\n");
+ return -ENODEV;
+ }
+
+ /* IO Size check */
+ if (pci_resource_len(pdev, 0) < io_size) {
+ printk(KERN_ERR "Insufficient PCI resources, aborting\n");
+ return -EIO;
+ }
+
+ pioaddr = pci_resource_start(pdev, 0); /* IO map base address */
+ pci_set_master(pdev);
+
+ dev = alloc_etherdev(sizeof(struct r6040_private));
+ if (!dev) {
+ printk(KERN_ERR "Failed to allocate etherdev\n");
+ return -ENOMEM;
+ }
+ SET_NETDEV_DEV(dev, &pdev->dev);
+ lp = netdev_priv(dev);
+
+ if (pci_request_regions(pdev, DRV_NAME)) {
+ printk(KERN_ERR DRV_NAME ": Failed to request PCI regions\n");
+ err = -ENODEV;
+ goto err_out_disable;
+ }
+
+ ioaddr = pci_iomap(pdev, bar, io_size);
+ if (!ioaddr) {
+ printk(KERN_ERR "ioremap failed for device %s\n",
+ pci_name(pdev));
+ return -EIO;
+ }
+
+ /* Init system & device */
+ lp->base = ioaddr;
+ dev->irq = pdev->irq;
+
+ spin_lock_init(&lp->lock);
+ pci_set_drvdata(pdev, dev);
+
+ card_idx++;
+
+ /* Link new device into r6040_root_dev */
+ lp->pdev = pdev;
+
+ lp->dev = dev;
+
+ /* Init RDC private data */
+ lp->mcr0 = 0x1002;
+ lp->phy_addr = phy_table[card_idx];
+ lp->switch_sig = 0;
+
+ /* The RDC-specific entries in the device structure. */
+ dev->open = &r6040_open;
+ dev->hard_start_xmit = &r6040_start_xmit;
+ dev->stop = &r6040_close;
+ dev->get_stats = r6040_get_stats;
+ dev->set_multicast_list = &r6040_multicast_list;
+ dev->do_ioctl = &r6040_ioctl;
+ dev->ethtool_ops = &netdev_ethtool_ops;
+ dev->tx_timeout = &r6040_tx_timeout;
+ dev->watchdog_timeo = TX_TIMEOUT;
+
+ {
+ /* TODO: fix the setting of the MAC address.
+ Right now you must either specify a netdevice with "parent=", whose
+ address is copied or the (default) address of the Sitecom WL-153
+ bootloader is used */
+ static const u8 dflt_addr[ETH_ALEN] = {0,0x50,0xfc,2,3,4};
+ if (parent_dev) {
+ memcpy(dev->dev_addr, parent_dev->dev_addr, ETH_ALEN);
+ } else {
+ printk(KERN_WARNING "%s: no parent - using default mac address\n",
+ dev->name);
+ memcpy(dev->dev_addr, dflt_addr, ETH_ALEN);
+ }
+ dev->dev_addr[ETH_ALEN-1] += card_idx ^ 1; /* + 0 or 1 */
+ }
+
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ dev->poll_controller = r6040_poll_controller;
+#endif
+ netif_napi_add(dev, &lp->napi, r6040_poll, 64);
+ lp->mii_if.dev = dev;
+ lp->mii_if.mdio_read = mdio_read;
+ lp->mii_if.mdio_write = mdio_write;
+ lp->mii_if.phy_id = lp->phy_addr;
+ lp->mii_if.phy_id_mask = 0x1f;
+ lp->mii_if.reg_num_mask = 0x1f;
+
+ /* Register net device. After this dev->name assign */
+ err = register_netdev(dev);
+ if (err) {
+ printk(KERN_ERR DRV_NAME ": Failed to register net device\n");
+ goto err_out_res;
+ }
+
+ dbg(DBG_INIT, "%s successfully registered\n", dev->name);
+ return 0;
+
+err_out_res:
+ pci_release_regions(pdev);
+err_out_disable:
+ pci_disable_device(pdev);
+ pci_set_drvdata(pdev, NULL);
+ free_netdev(dev);
+
+ return err;
+}
+
+void __devexit r6040_remove_one(struct pci_dev *pdev)
+{
+ struct net_device *dev = pci_get_drvdata(pdev);
+
+ unregister_netdev(dev);
+ pci_release_regions(pdev);
+ free_netdev(dev);
+ pci_disable_device(pdev);
+ pci_set_drvdata(pdev, NULL);
+}
+
+