--- a/drivers/net/wireless/b43/b43.h
+++ b/drivers/net/wireless/b43/b43.h
-@@ -718,6 +718,7 @@ struct b43_wldev {
+@@ -740,6 +740,7 @@ struct b43_wldev {
bool qos_enabled; /* TRUE, if QoS is used. */
bool hwcrypto_enabled; /* TRUE, if HW crypto acceleration is enabled. */
bool use_pio; /* TRUE if next init should use PIO */
struct b43_phy phy;
--- a/drivers/net/wireless/b43/main.c
+++ b/drivers/net/wireless/b43/main.c
-@@ -75,6 +75,11 @@ MODULE_FIRMWARE("b43/ucode15.fw");
+@@ -76,6 +76,11 @@ MODULE_FIRMWARE("b43/ucode16_mimo.fw");
MODULE_FIRMWARE("b43/ucode5.fw");
MODULE_FIRMWARE("b43/ucode9.fw");
static int modparam_bad_frames_preempt;
module_param_named(bad_frames_preempt, modparam_bad_frames_preempt, int, 0444);
MODULE_PARM_DESC(bad_frames_preempt,
-@@ -2542,10 +2547,10 @@ static int b43_gpio_init(struct b43_wlde
+@@ -2575,10 +2580,10 @@ static int b43_gpio_init(struct b43_wlde
& ~B43_MACCTL_GPOUTSMSK);
b43_write16(dev, B43_MMIO_GPIO_MASK, b43_read16(dev, B43_MMIO_GPIO_MASK)
mask = 0x0000001F;
- set = 0x0000000F;
+ set = modparam_gpiomask;
- if (dev->dev->bus->chip_id == 0x4301) {
+ if (dev->dev->chip_id == 0x4301) {
mask |= 0x0060;
set |= 0x0060;
-@@ -5100,10 +5105,10 @@ static void b43_print_driverinfo(void)
+@@ -5137,10 +5142,10 @@ static void b43_print_driverinfo(void)
feat_sdio = "S";
#endif
printk(KERN_INFO "Broadcom 43xx driver loaded "