ath9k: add a small hack to make changing the channel bandwidth to 5/10 mhz available...

[openwrt.git] / package / mac80211 / patches / 800-b43-gpio-mask-module-option.patch

diff --git a/package/mac80211/patches/800-b43-gpio-mask-module-option.patch b/package/mac80211/patches/800-b43-gpio-mask-module-option.patch
index eebda2a..1dee123 100644 (file)
--- a/package/mac80211/patches/800-b43-gpio-mask-module-option.patch
+++ b/package/mac80211/patches/800-b43-gpio-mask-module-option.patch
@@ -1,6 +1,6 @@
 --- a/drivers/net/wireless/b43/b43.h
 +++ b/drivers/net/wireless/b43/b43.h
-@@ -718,6 +718,7 @@ struct b43_wldev {
+@@ -740,6 +740,7 @@ struct b43_wldev {
        bool qos_enabled;               /* TRUE, if QoS is used. */
        bool hwcrypto_enabled;          /* TRUE, if HW crypto acceleration is enabled. */
        bool use_pio;                   /* TRUE if next init should use PIO */
@@ -10,7 +10,7 @@
        struct b43_phy phy;
 --- a/drivers/net/wireless/b43/main.c
 +++ b/drivers/net/wireless/b43/main.c
-@@ -75,6 +75,11 @@ MODULE_FIRMWARE("b43/ucode15.fw");
+@@ -76,6 +76,11 @@ MODULE_FIRMWARE("b43/ucode16_mimo.fw");
  MODULE_FIRMWARE("b43/ucode5.fw");
  MODULE_FIRMWARE("b43/ucode9.fw");
  
@@ -22,7 +22,7 @@
  static int modparam_bad_frames_preempt;
  module_param_named(bad_frames_preempt, modparam_bad_frames_preempt, int, 0444);
  MODULE_PARM_DESC(bad_frames_preempt,
-@@ -2542,10 +2547,10 @@ static int b43_gpio_init(struct b43_wlde
+@@ -2575,10 +2580,10 @@ static int b43_gpio_init(struct b43_wlde
                    & ~B43_MACCTL_GPOUTSMSK);
  
        b43_write16(dev, B43_MMIO_GPIO_MASK, b43_read16(dev, B43_MMIO_GPIO_MASK)
@@ -32,10 +32,10 @@
        mask = 0x0000001F;
 -      set = 0x0000000F;
 +      set = modparam_gpiomask;
-       if (dev->dev->bus->chip_id == 0x4301) {
+       if (dev->dev->chip_id == 0x4301) {
                mask |= 0x0060;
                set |= 0x0060;
-@@ -5102,10 +5107,10 @@ static void b43_print_driverinfo(void)
+@@ -5137,10 +5142,10 @@ static void b43_print_driverinfo(void)
        feat_sdio = "S";
  #endif
        printk(KERN_INFO "Broadcom 43xx driver loaded "