Add missing .configured target and fix .prepared target that caused superfluous packa...

[openwrt.git] / openwrt / scripts / flash.sh

diff --git a/openwrt/scripts/flash.sh b/openwrt/scripts/flash.sh
index aedb250..e711086 100644 (file)
--- a/openwrt/scripts/flash.sh
+++ b/openwrt/scripts/flash.sh
@@ -24,16 +24,14 @@ if [ -z "$1" ] || [ ! -f $1 ] || [ -z $2 ]; then
     echo Usage: $0 firmware vendor
 cat << EOF
 IMPORTANT:
     echo Usage: $0 firmware vendor
 cat << EOF
 IMPORTANT:

-Notes for Linksys Routers: 
+Notes for Linksys router: 

    be sure you have set boot_wait to yes. Power on your router
    after executing this script.
    be sure you have set boot_wait to yes. Power on your router
    after executing this script.

-   Use openwrt-gs-code.bin or openwrt-g-code.bin as firmware.

  
  

-Notes for Asus Routers:
-   be sure POWER led is flashing (If this is not a case
+Notes for Asus router:
+   be sure POWER led is flashing (If this is not the case

    poweroff the device, push the reset button & power on
    it again, then release button)
    poweroff the device, push the reset button & power on
    it again, then release button)

-   Use openwrt-linux.trx as firmware.

 
 1) connect your pc to the LAN port
 2) be sure your link is up and has an address in the
 
 1) connect your pc to the LAN port
 2) be sure your link is up and has an address in the


@@ -50,5 +48,5 @@ echo Please wait until leds stops flashing.
 elif [ "$2" == "linksys" ]; then
 echo Flashing 192.168.1.1 using $1...
 echo -en "rexmt 1\ntrace\nbinary\nput $1\nquit\n" | tftp 192.168.1.1
 elif [ "$2" == "linksys" ]; then
 echo Flashing 192.168.1.1 using $1...
 echo -en "rexmt 1\ntrace\nbinary\nput $1\nquit\n" | tftp 192.168.1.1

-echo Please wait until power led stops flashing. Then you can login via telnet 192.168.1.1
+echo Please wait until power led stops flashing. Do not poweroff! Then you can login via telnet 192.168.1.1.

 fi
 fi