#define BCM43xx_SHM_SH_ANTSWAP 0x005C /* Antenna swap threshold */
#define BCM43xx_SHM_SH_HOSTFLO 0x005E /* Hostflags for ucode options (low) */
#define BCM43xx_SHM_SH_HOSTFHI 0x0060 /* Hostflags for ucode options (high) */
+#define BCM43xx_SHM_SH_RFATT 0x0064 /* Current radio attenuation value */
#define BCM43xx_SHM_SH_RADAR 0x0066 /* Radar register */
#define BCM43xx_SHM_SH_PHYTXNOI 0x006E /* PHY noise directly after TX (lower 8bit only) */
#define BCM43xx_SHM_SH_RFRXSP1 0x0072 /* RF RX SP Register 1 */
/* MacFilter offsets. */
#define BCM43xx_MACFILTER_SELF 0x0000
-#define BCM43xx_MACFILTER_ASSOC 0x0003
+#define BCM43xx_MACFILTER_BSSID 0x0003
/* PowerControl */
#define BCM43xx_PCTL_IN 0xB0
/* Desired TX power level (in dBm).
* This is set by the user and adjusted in bcm43xx_phy_xmitpower(). */
u8 power_level;
- /* TX Power control values. */
- /* B/G PHY */
- struct {
- /* Current Radio Attenuation for TXpower recalculation. */
- u16 rfatt;
- /* Current Baseband Attenuation for TXpower recalculation. */
- u16 bbatt;
- /* Current TXpower control value for TXpower recalculation. */
- u16 txctl1;
- };
- /* A PHY */
- struct {
- u16 txpwr_offset;
- };
+ /* A-PHY TX Power control value. */
+ u16 txpwr_offset;
+
+ /* Current TX power level attenuation control values */
+ struct bcm43xx_bbatt bbatt;
+ struct bcm43xx_rfatt rfatt;
+ u8 tx_control; /* BCM43xx_TXCTL_XXX */
+#ifdef CONFIG_BCM43XX_MAC80211_DEBUG
+ u8 manual_txpower_control; /* Manual TX-power control enabled? */
+#endif
/* Current Interference Mitigation mode */
int interfmode;
* Do not modify.
*/
int if_id;
- /* MAC address. */
- u8 *mac_addr;
- /* Current BSSID (if any). */
- u8 *bssid;
+ /* MAC address (can be NULL). */
+ const u8 *mac_addr;
+ /* Current BSSID (can be NULL). */
+ const u8 *bssid;
/* Interface type. (IEEE80211_IF_TYPE_XXX) */
int if_type;
/* Counter of active monitor interfaces. */
__value; \
})
+/* Macros for printing a value in Q5.2 format */
+#define Q52_FMT "%u.%u"
+#define Q52_ARG(q52) ((q52) / 4), ((((q52) & 3) * 100) / 4)
+
#endif /* BCM43xx_H_ */