27a1ac104e1f996bd8893e23af33f15582597ae7
[openwrt.git] / package / mac80211 / patches / 800-b43-gpio-mask-module-option.patch
1 --- a/drivers/net/wireless/b43/b43.h
2 +++ b/drivers/net/wireless/b43/b43.h
3 @@ -720,6 +720,7 @@ struct b43_wldev {
4 bool qos_enabled; /* TRUE, if QoS is used. */
5 bool hwcrypto_enabled; /* TRUE, if HW crypto acceleration is enabled. */
6 bool use_pio; /* TRUE if next init should use PIO */
7 + int gpiomask; /* GPIO LED mask as a module parameter */
8
9 /* PHY/Radio device. */
10 struct b43_phy phy;
11 --- a/drivers/net/wireless/b43/main.c
12 +++ b/drivers/net/wireless/b43/main.c
13 @@ -76,6 +76,11 @@ MODULE_FIRMWARE("b43/ucode16_mimo.fw");
14 MODULE_FIRMWARE("b43/ucode5.fw");
15 MODULE_FIRMWARE("b43/ucode9.fw");
16
17 +static int modparam_gpiomask = 0x000F;
18 +module_param_named(gpiomask, modparam_gpiomask, int, 0444);
19 +MODULE_PARM_DESC(gpiomask,
20 + "GPIO mask for LED control (default 0x000F)");
21 +
22 static int modparam_bad_frames_preempt;
23 module_param_named(bad_frames_preempt, modparam_bad_frames_preempt, int, 0444);
24 MODULE_PARM_DESC(bad_frames_preempt,
25 @@ -2560,10 +2565,10 @@ static int b43_gpio_init(struct b43_wlde
26 & ~B43_MACCTL_GPOUTSMSK);
27
28 b43_write16(dev, B43_MMIO_GPIO_MASK, b43_read16(dev, B43_MMIO_GPIO_MASK)
29 - | 0x000F);
30 + | modparam_gpiomask);
31
32 mask = 0x0000001F;
33 - set = 0x0000000F;
34 + set = modparam_gpiomask;
35 if (dev->sdev->bus->chip_id == 0x4301) {
36 mask |= 0x0060;
37 set |= 0x0060;
38 @@ -5084,10 +5089,10 @@ static void b43_print_driverinfo(void)
39 feat_sdio = "S";
40 #endif
41 printk(KERN_INFO "Broadcom 43xx driver loaded "
42 - "[ Features: %s%s%s%s%s, Firmware-ID: "
43 + "[ Features: %s%s%s%s%s, GPIO LED Mask: 0x%04x, Firmware-ID: "
44 B43_SUPPORTED_FIRMWARE_ID " ]\n",
45 feat_pci, feat_pcmcia, feat_nphy,
46 - feat_leds, feat_sdio);
47 + feat_leds, feat_sdio, modparam_gpiomask);
48 }
49
50 static int __init b43_init(void)
This page took 0.040206 seconds and 3 git commands to generate.