[rdc] include swconfig in ar525w profile

[openwrt.git] / scripts / arm-magic.sh

diff --git a/scripts/arm-magic.sh b/scripts/arm-magic.sh
index 2a82a33..8bc35c1 100755 (executable)
--- a/scripts/arm-magic.sh
+++ b/scripts/arm-magic.sh
@@ -22,17 +22,17 @@
 # NOTE: for now it's for only IXP4xx in big endian mode
 
 # list of supported boards, in "boardname machtypeid" format
-for board in "avila 526" "gateway7001 731" "nslu2 597" "nas100d 865" "wg302v2 890" "pronghornmetro 1040" "compex 1273" "wrt300nv2 1077" "loft 849" "dsmg600 964" "fsg3 1091"
+for board in "avila 526" "gateway7001 731" "nslu2 597" "nas100d 865" "wg302v1 889" "wg302v2 890" "pronghorn 928" "pronghornmetro 1040" "compex 1273" "wrt300nv2 1077" "loft 849" "dsmg600 964" "fsg3 1091" "ap1000 1543" "tw2662 1658" "tw5334 1664" "ixdpg425 604" "cambria 1468" "sidewinder 1041"
 do
   set -- $board
   hexid=$(printf %x\\n $2)
   if [ "$2" -lt "256" ]; then
     # we have a low machtypeid, we just need a "mov" (e3a)
-    printf "\xe3\xa0\x10\x$hexid" > $BIN_DIR/openwrt-$1-2.6-zImage
+    printf "\xe3\xa0\x10\x$hexid" > $BIN_DIR/openwrt-$1-zImage
   else
     # we have a high machtypeid, we need a "mov" (e3a) and an "orr" (e38)
-    printf "\xe3\xa0\x10\x$(echo $hexid|cut -b "2 3")\xe3\x81\x1c\x$(echo $hexid|cut -b 1)" > $BIN_DIR/openwrt-$1-2.6-zImage
+    printf "\xe3\xa0\x10\x$(echo $hexid|cut -b "2 3")\xe3\x81\x1c\x$(echo $hexid|cut -b 1)" > $BIN_DIR/openwrt-$1-zImage
   fi
     # generate the image
-    cat $BIN_DIR/openwrt-ixp4xx-2.6-zImage >> $BIN_DIR/openwrt-$1-2.6-zImage
+    cat $BIN_DIR/$IMG_PREFIX-zImage >> $BIN_DIR/openwrt-$1-zImage
 done