Revert "[brcm47xx] Add support for cores with slow WDT clock (bcm5354)"
[openwrt.git] / target / linux / brcm47xx / patches-2.6.34 / 700-ssb-gigabit-ethernet-driver.patch
index f2493dd..bf6ffed 100644 (file)
@@ -8,7 +8,7 @@
  
  #include <net/checksum.h>
  #include <net/ip.h>
-@@ -471,8 +472,9 @@ static void _tw32_flush(struct tg3 *tp, 
+@@ -471,8 +472,9 @@ static void _tw32_flush(struct tg3 *tp,
  static inline void tw32_mailbox_flush(struct tg3 *tp, u32 off, u32 val)
  {
        tp->write32_mbox(tp, off, val);
@@ -61,7 +61,7 @@
  {
        u32 frame_val;
        unsigned int loops;
-@@ -848,7 +855,7 @@ static int tg3_writephy(struct tg3 *tp, 
+@@ -848,7 +855,7 @@ static int tg3_writephy(struct tg3 *tp,
                udelay(80);
        }
  
@@ -70,7 +70,7 @@
                      MI_COM_PHY_ADDR_MASK);
        frame_val |= ((reg << MI_COM_REG_ADDR_SHIFT) &
                      MI_COM_REG_ADDR_MASK);
-@@ -881,6 +888,11 @@ static int tg3_writephy(struct tg3 *tp, 
+@@ -881,6 +888,11 @@ static int tg3_writephy(struct tg3 *tp,
        return ret;
  }
  
  
 +              if (tp->tg3_flags3 & TG3_FLG3_ROBOSWITCH) {
 +                      current_link_up = 1;
-+                      current_speed = SPEED_1000; //FIXME
++                      current_speed = SPEED_1000; /* FIXME */
 +                      current_duplex = DUPLEX_FULL;
 +                      tp->link_config.active_speed = current_speed;
 +                      tp->link_config.active_duplex = current_duplex;
        tw32(GRC_MODE, tp->grc_mode);
  
        if (tp->pci_chip_rev_id == CHIPREV_ID_5705_A0) {
-@@ -7135,9 +7173,12 @@ static int tg3_halt_cpu(struct tg3 *tp, 
+@@ -7135,9 +7173,12 @@ static int tg3_halt_cpu(struct tg3 *tp,
                return -ENODEV;
        }
  
        fw_data = (void *)tp->fw->data;
  
        /* Firmware blob starts with version numbers, followed by
-@@ -7256,6 +7302,11 @@ static int tg3_load_tso_firmware(struct 
+@@ -7256,6 +7302,11 @@ static int tg3_load_tso_firmware(struct
        unsigned long cpu_base, cpu_scratch_base, cpu_scratch_size;
        int err, i;
  
        if (!(tp->tg3_flags & TG3_FLAG_TAGGED_STATUS)) {
                /* All of this garbage is because when using non-tagged
                 * IRQ status the mailbox/status_block protocol the chip
-@@ -10278,6 +10334,11 @@ static int tg3_test_nvram(struct tg3 *tp
+@@ -10279,6 +10335,11 @@ static int tg3_test_nvram(struct tg3 *tp
        if (tp->tg3_flags3 & TG3_FLG3_NO_NVRAM)
                return 0;
  
        if (tg3_nvram_read(tp, 0, &magic) != 0)
                return -EIO;
  
-@@ -11097,7 +11158,7 @@ static int tg3_ioctl(struct net_device *
+@@ -11098,7 +11159,7 @@ static int tg3_ioctl(struct net_device *
                        return -EAGAIN;
  
                spin_lock_bh(&tp->lock);
                spin_unlock_bh(&tp->lock);
  
                data->val_out = mii_regval;
-@@ -11113,7 +11174,7 @@ static int tg3_ioctl(struct net_device *
+@@ -11114,7 +11175,7 @@ static int tg3_ioctl(struct net_device *
                        return -EAGAIN;
  
                spin_lock_bh(&tp->lock);
                spin_unlock_bh(&tp->lock);
  
                return err;
-@@ -11758,6 +11819,12 @@ static void __devinit tg3_get_5717_nvram
+@@ -11759,6 +11820,12 @@ static void __devinit tg3_get_5717_nvram
  /* Chips other than 5700/5701 use the NVRAM for fetching info. */
  static void __devinit tg3_nvram_init(struct tg3 *tp)
  {
        tw32_f(GRC_EEPROM_ADDR,
             (EEPROM_ADDR_FSM_RESET |
              (EEPROM_DEFAULT_CLOCK_PERIOD <<
-@@ -12019,6 +12086,9 @@ static int tg3_nvram_write_block(struct 
+@@ -12020,6 +12087,9 @@ static int tg3_nvram_write_block(struct
  {
        int ret;
  
        if (tp->tg3_flags & TG3_FLAG_EEPROM_WRITE_PROT) {
                tw32_f(GRC_LOCAL_CTRL, tp->grc_local_ctrl &
                       ~GRC_LCLCTRL_GPIO_OUTPUT1);
-@@ -13359,6 +13429,11 @@ static int __devinit tg3_get_invariants(
+@@ -13360,6 +13430,11 @@ static int __devinit tg3_get_invariants(
              GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5701)))
                tp->tg3_flags |= TG3_FLAG_SRAM_USE_CONFIG;
  
        /* Get eeprom hw config before calling tg3_set_power_state().
         * In particular, the TG3_FLG2_IS_NIC flag must be
         * determined before calling tg3_set_power_state() so that
-@@ -13752,6 +13827,10 @@ static int __devinit tg3_get_device_addr
+@@ -13753,6 +13828,10 @@ static int __devinit tg3_get_device_addr
        }
  
        if (!is_valid_ether_addr(&dev->dev_addr[0])) {
  #ifdef CONFIG_SPARC
                if (!tg3_get_default_macaddr_sparc(tp))
                        return 0;
-@@ -14271,6 +14350,7 @@ static char * __devinit tg3_phy_string(s
+@@ -14272,6 +14351,7 @@ static char * __devinit tg3_phy_string(s
        case TG3_PHY_ID_BCM5704:        return "5704";
        case TG3_PHY_ID_BCM5705:        return "5705";
        case TG3_PHY_ID_BCM5750:        return "5750";
        case TG3_PHY_ID_BCM5752:        return "5752";
        case TG3_PHY_ID_BCM5714:        return "5714";
        case TG3_PHY_ID_BCM5780:        return "5780";
-@@ -14480,6 +14560,13 @@ static int __devinit tg3_init_one(struct
+@@ -14481,6 +14561,13 @@ static int __devinit tg3_init_one(struct
                tp->msg_enable = tg3_debug;
        else
                tp->msg_enable = TG3_DEF_MSG_ENABLE;
This page took 0.030313 seconds and 4 git commands to generate.