add original danube led driver

[openwrt.git] / target / linux / adm5120 / router_be / config-2.6.23

diff --git a/target/linux/adm5120/router_be/config-2.6.23 b/target/linux/adm5120/router_be/config-2.6.23
index 09c23bc..38c643a 100644 (file)
--- a/target/linux/adm5120/router_be/config-2.6.23
+++ b/target/linux/adm5120/router_be/config-2.6.23
@@ -89,9 +89,10 @@ CONFIG_IP_NF_TARGET_CLUSTERIP=m
 CONFIG_IRQ_CPU=y
 # CONFIG_JOLIET is not set
 CONFIG_LEDS_ADM5120=m
-CONFIG_LEDS_ADM5120_DIAG=y
+# CONFIG_LEDS_ADM5120_DIAG is not set
 # CONFIG_LEDS_ADM5120_EXPERIMENTAL is not set
 CONFIG_LEDS_GPIO=m
+CONFIG_LEDS_TRIGGER_ADM5120_SWITCH=m
 CONFIG_LEGACY_PTYS=y
 CONFIG_LEGACY_PTY_COUNT=256
 # CONFIG_LEMOTE_FULONG is not set
@@ -162,14 +163,10 @@ CONFIG_MTD_PARTITIONS=y
 # CONFIG_MTD_SLRAM is not set
 CONFIG_MTD_TRXSPLIT=y
 CONFIG_NETDEV_1000=y
-CONFIG_NET_ACT_POLICE=y
 CONFIG_NET_KEY=y
 # CONFIG_NET_PCI is not set
 # CONFIG_NET_PKTGEN is not set
-CONFIG_NET_SCH_FIFO=y
 # CONFIG_NET_VENDOR_3COM is not set
-CONFIG_NF_CT_PROTO_GRE=m
-CONFIG_NF_NAT_PROTO_GRE=m
 # CONFIG_NO_IOPORT is not set
 # CONFIG_PAGE_SIZE_16KB is not set
 CONFIG_PAGE_SIZE_4KB=y
@@ -178,16 +175,15 @@ CONFIG_PAGE_SIZE_4KB=y
 # CONFIG_PARTITION_ADVANCED is not set
 # CONFIG_PCIPCWATCHDOG is not set
 CONFIG_PCI_ADM5120=y
+CONFIG_PCI_DISABLE_COMMON_QUIRKS=y
 # CONFIG_PMC_MSP is not set
 # CONFIG_PMC_YOSEMITE is not set
 # CONFIG_PNX8550_JBS is not set
 # CONFIG_PNX8550_STB810 is not set
 # CONFIG_RTC is not set
-# CONFIG_RTL8187 is not set
 CONFIG_RWSEM_GENERIC_SPINLOCK=y
 CONFIG_SCHED_NO_NO_OMIT_FRAME_POINTER=y
 CONFIG_SCSI_WAIT_SCAN=m
-# CONFIG_SENSORS_ABITUGURU3 is not set
 # CONFIG_SENSORS_PC87360 is not set
 # CONFIG_SERIAL_8250 is not set
 # CONFIG_SERIAL_ADM5120 is not set
@@ -230,7 +226,6 @@ CONFIG_TMPFS_POSIX_ACL=y
 # CONFIG_TOSHIBA_RBTX4927 is not set
 # CONFIG_TOSHIBA_RBTX4938 is not set
 CONFIG_TRAD_SIGNALS=y
-# CONFIG_UNUSED_SYMBOLS is not set
 # CONFIG_USBPCWATCHDOG is not set
 # CONFIG_USB_ACM is not set
 CONFIG_USB_ADM5120_HCD=m