Change order of module startup to force USB2 before USB1.1

[openwrt.git] / target / linux / brcm-2.4 / base-files / etc / init.d / netconfig

diff --git a/target/linux/brcm-2.4/base-files/etc/init.d/netconfig b/target/linux/brcm-2.4/base-files/etc/init.d/netconfig
index 643ba35..44e2de2 100755 (executable)
--- a/target/linux/brcm-2.4/base-files/etc/init.d/netconfig
+++ b/target/linux/brcm-2.4/base-files/etc/init.d/netconfig
@@ -61,7 +61,17 @@ start() {
                        c["wan_ifname"] = "eth1"
                        c["lan_ifname"] = "eth0"
                }
+               if (model == "ASUS WL-500g Premium V2") {
+                               c["vlan0ports"] = "0 1 2 3 5*"
+                               c["vlan1ports"] = "4 5"
+               }
                if (model == "Dell TrueMobile 2300") {
+                       c["lan_ifname"] = "eth0"
+                       c["wan_ifname"] = "eth1"
+                       c["vlan0ports"] = "0 1 2 3 4 5u"
+                       c["vlan1ports"] = ""
+               }
+               if (model == "Dell TrueMobile 2300 v2") {
                        c["vlan0ports"] = "0 1 2 3 5*"
                        c["vlan1ports"] = "4 5"
                }
@@ -97,6 +107,11 @@ start() {
                                }
                        }
                }
+               if (nvram["boardtype"] == "0x478") {
+                       # generic broadcom 4785 processor with 5397 switch?
+                       c["vlan0ports"] = "1 2 3 4 8*"
+                       c["vlan1ports"] = "0 8"
+               }
 
                # WAP54G
                if ((nvram["boardnum"] == "2") || \
@@ -105,6 +120,13 @@ start() {
                        c["wan_ifname"]=""
                }
 
+               # Sitecom WL-105b
+               if ((nvram["boardum"] == "2") && \
+                       (nvram["GemtekPmonVer"] == "1")) {
+                       c["lan_ifname"]="eth0"
+                       c["wan_ifname"]=""
+               }
+
                # ASUS WL-700gE
                # These are actually same as defaults above. For some reason this script applies
                # Generic BCM94704 settings instead so we revert to proper settings here.
@@ -120,6 +142,12 @@ start() {
                        c["vlan0ports"]="0 1 2 3 5*"
                        c["vlan1ports"]="4 5"
                }
+               if (model == "ASUS WL-500W") {
+                       c["lan_ifname"] = "eth0"
+                       c["wan_ifname"] = "eth1"
+                       c["vlan0ports"] = "0 1 2 3 4 5u"
+                       c["vlan1ports"] = ""
+               }
 
                print "#### VLAN configuration "
                print "config switch eth0"