check config changes on make world

[openwrt.git] / openwrt / scripts / flash.sh

diff --git a/openwrt/scripts/flash.sh b/openwrt/scripts/flash.sh
index aedb250..e711086 100644 (file)
--- a/openwrt/scripts/flash.sh
+++ b/openwrt/scripts/flash.sh
@@ -24,16 +24,14 @@ if [ -z "$1" ] || [ ! -f $1 ] || [ -z $2 ]; then
     echo Usage: $0 firmware vendor
 cat << EOF
 IMPORTANT:
-Notes for Linksys Routers: 
+Notes for Linksys router: 
    be sure you have set boot_wait to yes. Power on your router
    after executing this script.
-   Use openwrt-gs-code.bin or openwrt-g-code.bin as firmware.
  
-Notes for Asus Routers:
-   be sure POWER led is flashing (If this is not a case
+Notes for Asus router:
+   be sure POWER led is flashing (If this is not the case
    poweroff the device, push the reset button & power on
    it again, then release button)
-   Use openwrt-linux.trx as firmware.
 
 1) connect your pc to the LAN port
 2) be sure your link is up and has an address in the
@@ -50,5 +48,5 @@ echo Please wait until leds stops flashing.
 elif [ "$2" == "linksys" ]; then
 echo Flashing 192.168.1.1 using $1...
 echo -en "rexmt 1\ntrace\nbinary\nput $1\nquit\n" | tftp 192.168.1.1
-echo Please wait until power led stops flashing. Then you can login via telnet 192.168.1.1
+echo Please wait until power led stops flashing. Do not poweroff! Then you can login via telnet 192.168.1.1.
 fi