brcm47xx: update bcma and ssb to master-2011-07-21
[openwrt.git] / target / linux /
2011-07-22 haukebrcm47xx: update bcma and ssb to master-2011-07-21
2011-07-22 haukekernel: update to linux-3.0 and refresh patches.
2011-07-20 nbdar71xx: reinitialize global switch settings after reset...
2011-07-20 nbdar71xx: configure address aging on ar7240
2011-07-20 nbdar71xx: reset the phy in the ethernet init on ar724x
2011-07-20 nbdar71xx: make sure that rx and interrupts are disabled...
2011-07-20 nbdar71xx: increase the delay after the ethernet MAC reset
2011-07-20 nbdar71xx: fix an unused variable warning
2011-07-19 blogicsync default kernel config for lantiq danube/ar9
2011-07-19 blogicfix etehrnet when using EPHY on lantiq ASE
2011-07-19 blogicfixes pci on lantiq AR9 SoC
2011-07-19 blogicadd support for more lantiq AR9 boards
2011-07-19 nbdkernel: backport and enable tmpfs xattr support for...
2011-07-18 blogic[lantiq]
2011-07-17 blogic[lantiq]
2011-07-17 florian[ar7] add additionnal debug symbols when kernel debuggi...
2011-07-16 florian[brcm63xx] add ehci support to DWV-S0 board (#9059)
2011-07-13 florian[brcm63xx] fix GEN_SPI_RSET_BASE macro (#9697)
2011-07-12 kaloz[generic]: upgrade to 3.0-rc7
2011-07-11 kaloz[orion]: upgrade to 3.0-rc6 and optimize for armv5te...
2011-07-09 nbdar71xx: do not reset the hardware on transmit timeout...
2011-07-09 nbdag71xx: keep the rx engine stopped while the link is...
2011-07-08 kaloz[cns3xxx/3.0]: use the new upstream l2cache and wdt...
2011-07-08 kaloz[generic/3.0]: add mpcore_wdt fixes
2011-07-07 blogicfix generation of falcon images for profiles
2011-07-07 blogicadds 2 ASC related patches to lantiq
2011-07-07 blogicfix up falcon kernel config
2011-07-07 blogicfix i2c-falcon kmod package selection
2011-07-07 blogicreplace all references to xway with danube
2011-07-07 blogicfix lantiq image makefile to represent new split betwee...
2011-07-07 blogicadd ar9 specific profile
2011-07-07 blogicrename xway profile to danube and remove ar9 specifics
2011-07-07 blogicremove ar9 board from xway profiles
2011-07-07 blogicremove CONFIG_MTD_PARTITIONS references from lantiq...
2011-07-07 kaloz[cns3xxx]: refresh patches
2011-07-07 kaloz[cns3xxx]: refresh patches
2011-07-07 kaloz[cns3xxx]: enable smp support
2011-07-07 kaloz[cns3xxx]: make smp code more similar to upstream
2011-07-07 kaloz[generic/3.0]: 3.0 is at rc6 now
2011-07-07 juhosgar71xx: build image for the AP121 boards with 4M of...
2011-07-07 juhosgar71xx: add separate profiles for the AP121 and AP121...
2011-07-07 kaloz[generic/3.0]: add support for and switch to XZ compres...
2011-07-07 kaloz[cns3xxx]: select the right cpu
2011-07-07 florian[kernel] fix building of perf for arm on uclibc
2011-07-07 florian[realview] enable support for perf events
2011-07-07 florian[malta] enable perf counter support
2011-07-07 cshore[ar7] base-files: diag.sh: added failsafe led definition
2011-07-06 blogic[lantiq] get ready for 3.0
2011-07-06 juhosgramips: fix buffalo image generation
2011-07-06 kaloz[ixp4xx]: add 3.0 support
2011-07-06 kalozrefresh patches
2011-07-06 kaloz[generic]: fixup mtd refresh and co.
2011-07-06 kaloz[generic/3.0]: fix myloader patch, thanks KanjiMonster
2011-07-06 blogicfixes mtd maps for lantiq easy50712 and easy50601 evalk...
2011-07-06 kaloz[cns3xxx]: we have an up-to-date mach-type file now
2011-07-06 kaloz[generic/3.0]: replace the cut down machtype with the...
2011-07-06 florian[brcm63xx] move board_HW553 inside the ifdef ..BCM6358...
2011-07-06 florian[kernel] refresh 2.6.39 geode patches
2011-07-06 juhosgramips: add diag support for RT-N15 and PWH2004
2011-07-06 juhosgramips: use the 'router' LED for diagnostic on the...
2011-07-06 juhosgramips: create tftp image for the WHR-G300N board
2011-07-06 juhosgramips: create factory image for the WHR-G300N board
2011-07-06 cshore[brcm63xx] Makefile: fixed inclusion of kmod-leds-gpio...
2011-07-06 cshore[brcm63xx] profiles: GW6X00: fixed inclusion of both...
2011-07-05 kaloz[generic/3.0]: add some symbols
2011-07-05 florian[kernel] sched_connmark depends on NF_CONNTRACK_MARK...
2011-07-05 kaloz[target/generic/3.0]: add missing symbols
2011-07-04 florian[brcm63xx] hw553: fix missing has_uart0 in board defini...
2011-07-04 juhosgar71xx: fix building of squashfs images
2011-07-04 blogicset DEFAULT_SUBTARGET for lantiq/
2011-07-04 blogicfix broken falcon patches from last night
2011-07-04 juhosgramips: create factory image for DIR-300-B1
2011-07-04 nbdar71xx: add wzr-hp-ag300h sysupgrade support (patch...
2011-07-03 blogicAT91: flexibity: add system uci file
2011-07-03 blogicAT91: Add flexibity board support
2011-07-03 blogicalix2: add/subtract features as needed
2011-07-03 blogicuse netif_receive_skb on lantiq
2011-07-03 blogicautomatic subtarget enumaration
2011-07-03 blogicupdate lantiq/falcon patches
2011-07-03 blogicfix description for lantiq target
2011-07-03 juhosgramips: merge 2.6.39 patches
2011-07-03 juhosgramips: remove 2.6.37 stuff
2011-07-03 juhosgramips: switch to 2.6.39.2
2011-07-03 juhosgramips: add 2.6.39 support
2011-07-03 juhosgramips: add hotplug script to extract eeprom for the...
2011-07-03 juhosgramips: specify eeprom file name on RT305X
2011-07-03 juhosgramips: specify eeprom file name on RT288X
2011-07-03 juhosggeneric: add rt2x00_platform.h
2011-07-03 juhosgramips: add all supported boards to lib/ramips.sh
2011-07-03 juhosgramips: check the size of the uImage in image generation
2011-07-03 juhosgramips: use lowercase partiion names on the WCR150GN...
2011-07-03 juhosgramips: use different partition names in the DIR-300...
2011-07-03 juhosgramips: force word write on flashes with AMD cmdset...
2011-07-03 juhosgramips: update partition map for DIR-300-B1
2011-07-03 juhosgramips: consistently use 'firmware' name for sysupgrade...
2011-07-03 juhosgramips: fix a section mismatch warning
2011-07-03 juhosgramips: remove unused include from the common GPIO...
2011-07-03 juhosgramips: disable watchdog on sysupgrade
2011-07-03 juhosgramips: swap target check in image generation
2011-07-03 juhosgramips: update HW550-3G mtd partitions
next
This page took 0.052195 seconds and 7 git commands to generate.