[brcm63xx] only register fallback sprom and enable PCI if we actually have support...

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@16581 3c298f89-4303-0410-b956-a3cf2f4a3e73

diff --git a/target/linux/brcm63xx/files/arch/mips/bcm63xx/boards/board_bcm963xx.c b/target/linux/brcm63xx/files/arch/mips/bcm63xx/boards/board_bcm963xx.c
index ff7cf56..3e767d8 100644 (file)
--- a/target/linux/brcm63xx/files/arch/mips/bcm63xx/boards/board_bcm963xx.c
+++ b/target/linux/brcm63xx/files/arch/mips/bcm63xx/boards/board_bcm963xx.c
@@ -378,13 +378,13 @@ void __init board_prom_init(void)
         * this has to be done this early since PCI init is done
         * inside arch_initcall */
        val = 0;
-
+#ifdef CONFIG_PCI
        if (board.has_pci) {
                bcm63xx_pci_enabled = 1;
                if (BCMCPU_IS_6348())
                        val |= GPIO_MODE_6348_G2_PCI;
        }
-
+#endif
        if (board.has_pccard) {
                if (BCMCPU_IS_6348())
                        val |= GPIO_MODE_6348_G1_MII_PCCARD;
@@ -538,12 +538,14 @@ int __init board_register_devices(void)
                bcm63xx_udc_register();
        /* Generate MAC address for WLAN and
         * register our SPROM */
+#ifdef CONFIG_PCI
        if (!board_get_mac_address(bcm63xx_sprom.il0mac)) {
                memcpy(bcm63xx_sprom.et0mac, bcm63xx_sprom.il0mac, ETH_ALEN);
                memcpy(bcm63xx_sprom.et1mac, bcm63xx_sprom.il0mac, ETH_ALEN);
                if (ssb_arch_set_fallback_sprom(&bcm63xx_sprom) < 0)
                        printk(KERN_ERR "failed to register fallback SPROM\n");
        }
+#endif
 
        /* read base address of boot chip select (0) */
        val = bcm_mpi_readl(MPI_CSBASE_REG(0));