[adm5120] add custom GPIO-based I2C driver
[openwrt.git] / target / linux / adm5120 / patches-2.6.22 / 003-adm5120_switch.patch
1 Index: linux-2.6.22.1/drivers/net/Kconfig
2 ===================================================================
3 --- linux-2.6.22.1.orig/drivers/net/Kconfig
4 +++ linux-2.6.22.1/drivers/net/Kconfig
5 @@ -574,6 +574,10 @@ config MIPS_AU1X00_ENET
6 If you have an Alchemy Semi AU1X00 based system
7 say Y. Otherwise, say N.
8
9 +config MIPS_ADM5120_ENET
10 + tristate "MIPS ADM5120 Ethernet switch support"
11 + depends on NET_ETHERNET && MIPS_ADM5120
12 +
13 config NET_SB1250_MAC
14 tristate "SB1250 Ethernet support"
15 depends on NET_ETHERNET && SIBYTE_SB1xxx_SOC
16 Index: linux-2.6.22.1/drivers/net/Makefile
17 ===================================================================
18 --- linux-2.6.22.1.orig/drivers/net/Makefile
19 +++ linux-2.6.22.1/drivers/net/Makefile
20 @@ -165,6 +165,7 @@ obj-$(CONFIG_SC92031) += sc92031.o
21 # This is also a 82596 and should probably be merged
22 obj-$(CONFIG_LP486E) += lp486e.o
23
24 +obj-$(CONFIG_MIPS_ADM5120_ENET) += adm5120sw.o
25 obj-$(CONFIG_ETH16I) += eth16i.o
26 obj-$(CONFIG_ZORRO8390) += zorro8390.o
27 obj-$(CONFIG_HPLANCE) += hplance.o 7990.o
This page took 0.049493 seconds and 5 git commands to generate.