bcm63xx: add initial support for bcm6368 boards
[openwrt.git] / package / hostapd / patches / 100-pending_work.patch
1 --- a/src/ap/ieee802_11.c
2 +++ b/src/ap/ieee802_11.c
3 @@ -1488,13 +1488,6 @@ static void handle_assoc_cb(struct hosta
4 int new_assoc = 1;
5 struct ieee80211_ht_capabilities ht_cap;
6
7 - if (!ok) {
8 - hostapd_logger(hapd, mgmt->da, HOSTAPD_MODULE_IEEE80211,
9 - HOSTAPD_LEVEL_DEBUG,
10 - "did not acknowledge association response");
11 - return;
12 - }
13 -
14 if (len < IEEE80211_HDRLEN + (reassoc ? sizeof(mgmt->u.reassoc_resp) :
15 sizeof(mgmt->u.assoc_resp))) {
16 printf("handle_assoc_cb(reassoc=%d) - too short payload "
17 @@ -1502,11 +1495,6 @@ static void handle_assoc_cb(struct hosta
18 return;
19 }
20
21 - if (reassoc)
22 - status = le_to_host16(mgmt->u.reassoc_resp.status_code);
23 - else
24 - status = le_to_host16(mgmt->u.assoc_resp.status_code);
25 -
26 sta = ap_get_sta(hapd, mgmt->da);
27 if (!sta) {
28 printf("handle_assoc_cb: STA " MACSTR " not found\n",
29 @@ -1514,6 +1502,19 @@ static void handle_assoc_cb(struct hosta
30 return;
31 }
32
33 + if (!ok) {
34 + hostapd_logger(hapd, mgmt->da, HOSTAPD_MODULE_IEEE80211,
35 + HOSTAPD_LEVEL_DEBUG,
36 + "did not acknowledge association response");
37 + sta->flags &= ~WLAN_STA_ASSOC_REQ_OK;
38 + return;
39 + }
40 +
41 + if (reassoc)
42 + status = le_to_host16(mgmt->u.reassoc_resp.status_code);
43 + else
44 + status = le_to_host16(mgmt->u.assoc_resp.status_code);
45 +
46 if (status != WLAN_STATUS_SUCCESS)
47 goto fail;
48
49 @@ -1812,6 +1813,9 @@ void ieee802_11_rx_from_unknown(struct h
50
51 sta = ap_get_sta(hapd, src);
52 if (sta && (sta->flags & WLAN_STA_ASSOC)) {
53 + if (!hapd->conf->wds_sta)
54 + return;
55 +
56 if (wds && !(sta->flags & WLAN_STA_WDS)) {
57 wpa_printf(MSG_DEBUG, "Enable 4-address WDS mode for "
58 "STA " MACSTR " (aid %u)",
59 --- a/src/drivers/driver_nl80211.c
60 +++ b/src/drivers/driver_nl80211.c
61 @@ -2588,10 +2588,10 @@ static int wpa_driver_nl80211_capa(struc
62 drv->data_tx_status = info.data_tx_status;
63
64 /*
65 - * If poll command is supported mac80211 is new enough to
66 - * have everything we need to not need monitor interfaces.
67 + * If poll command and tx status are supported, mac80211 is new enough
68 + * to have everything we need to not need monitor interfaces.
69 */
70 - drv->use_monitor = !info.poll_command_supported;
71 + drv->use_monitor = !info.poll_command_supported || !info.data_tx_status;
72
73 if (drv->device_ap_sme && drv->use_monitor) {
74 /*
75 @@ -6267,8 +6267,8 @@ static int wpa_driver_nl80211_hapd_send_
76 pos = (u8 *) (hdr + 1);
77
78 if (qos) {
79 - /* add an empty QoS header if needed */
80 - pos[0] = 0;
81 + /* Set highest priority in QoS header */
82 + pos[0] = 7;
83 pos[1] = 0;
84 pos += 2;
85 }
86 @@ -7533,6 +7533,10 @@ static int i802_set_wds_sta(void *priv,
87 linux_set_iface_flags(drv->global->ioctl_sock, name, 1);
88 return i802_set_sta_vlan(priv, addr, name, 0);
89 } else {
90 + if (bridge_ifname)
91 + linux_br_del_if(drv->global->ioctl_sock, bridge_ifname,
92 + name);
93 +
94 i802_set_sta_vlan(priv, addr, bss->ifname, 0);
95 return wpa_driver_nl80211_if_remove(priv, WPA_IF_AP_VLAN,
96 name);
97 @@ -7900,7 +7904,12 @@ static int wpa_driver_nl80211_if_remove(
98 if (ifindex <= 0)
99 return -1;
100
101 + nl80211_remove_iface(drv, ifindex);
102 +
103 #ifdef HOSTAPD
104 + if (type != WPA_IF_AP_BSS)
105 + return 0;
106 +
107 if (bss->added_if_into_bridge) {
108 if (linux_br_del_if(drv->global->ioctl_sock, bss->brname,
109 bss->ifname) < 0)
110 @@ -7914,13 +7923,6 @@ static int wpa_driver_nl80211_if_remove(
111 "bridge %s: %s",
112 bss->brname, strerror(errno));
113 }
114 -#endif /* HOSTAPD */
115 -
116 - nl80211_remove_iface(drv, ifindex);
117 -
118 -#ifdef HOSTAPD
119 - if (type != WPA_IF_AP_BSS)
120 - return 0;
121
122 if (bss != &drv->first_bss) {
123 struct i802_bss *tbss;
This page took 0.056992 seconds and 5 git commands to generate.