target/linux/au1000/patches-2.6.32/004-state_led_phy_fix.patch

   1 --- a/drivers/net/au1000_eth.c
   2 +++ b/drivers/net/au1000_eth.c
   3 @@ -167,6 +167,15 @@ struct au1000_private *au_macs[NUM_ETH_I
   4  #  undef AU1XXX_PHY1_IRQ
   5  #endif
   6
   7 +#if defined(CONFIG_MIPS_MTX1)
   8 +/*
   9 + * 4G MeshCube (MTX-1) board
  10 + * PHY is at address 31 on MAC0
  11 + * autodetect fails if not searched for highest address !
  12 + */
  13 +# define AU1XXX_PHY_SEARCH_HIGHEST_ADDR
  14 +#endif
  15 +
  16  #if defined(AU1XXX_PHY0_BUSID) && (AU1XXX_PHY0_BUSID > 0)
  17  # error MAC0-associated PHY attached 2nd MACs MII bus not supported yet
  18  #endif
  19 @@ -484,6 +493,12 @@ static int mii_probe (struct net_device
  20         aup->old_duplex = -1;
  21         aup->phy_dev = phydev;
  22
  23 +#ifdef CONFIG_MIPS_MTX1
  24 +       /* set up ethernet jack LEDs on the 4G MeshCube (MTX-1 board) */
  25 +       printk(KERN_INFO "MTX-1 PHY: updating LED settings\n");
  26 +       phy_write(phydev, 0x11, 0xff80);
  27 +#endif
  28 +
  29         printk(KERN_INFO "%s: attached PHY driver [%s] "
  30                "(mii_bus:phy_addr=%s, irq=%d)\n", dev->name,
  31                phydev->drv->name, dev_name(&phydev->dev), phydev->irq);