linux: generic: add support for 3.1-rc1
[openwrt.git] / target / linux / ar71xx /
2011-08-05 juhosgar71xx: fix image generation
2011-08-04 juhosgar71xx: enable sysupgrade on the AP96 and DB120 boards
2011-08-04 juhosgar71xx: use the same test for AP121 and Zcomax sysupgra...
2011-08-04 juhosgar71xx: cleanup image generation Makefile
2011-08-04 nbdar71xx: fix ethernet FIFO state corruption on ar7240
2011-08-04 nbdag71xx: fix memory corruption issues on ar7240 on ether...
2011-08-04 nbdar71xx: fix MAC/MDIO reset mask handling
2011-08-02 nbdar71xx: add some hacks to work around the misalignment...
2011-07-28 jogoar71xx: merge WZR-HP-G301NH support into WZR-HP-G300NH
2011-07-24 nbdar71xx: autodetect rtl8366s/rtl8366rb on wzr-hp-g300nh
2011-07-24 nbdrtl8366: unify rtl8366s and rtl8366rb platform data
2011-07-24 nbdar71xx: enable the usb power regulator on the wzr-hp...
2011-07-20 nbdar71xx: reinitialize global switch settings after reset...
2011-07-20 nbdar71xx: configure address aging on ar7240
2011-07-20 nbdar71xx: reset the phy in the ethernet init on ar724x
2011-07-20 nbdar71xx: make sure that rx and interrupts are disabled...
2011-07-20 nbdar71xx: increase the delay after the ethernet MAC reset
2011-07-20 nbdar71xx: fix an unused variable warning
2011-07-09 nbdar71xx: do not reset the hardware on transmit timeout...
2011-07-09 nbdag71xx: keep the rx engine stopped while the link is...
2011-07-07 juhosgar71xx: build image for the AP121 boards with 4M of...
2011-07-07 juhosgar71xx: add separate profiles for the AP121 and AP121...
2011-07-04 juhosgar71xx: fix building of squashfs images
2011-07-04 nbdar71xx: add wzr-hp-ag300h sysupgrade support (patch...
2011-07-02 juhosgar71xx: use 4k image only for the AP121 board
2011-07-01 jow[ar71xx] revert r27043 (#9513)
2011-07-01 jow[ar71xx] revert r27341, it introduce wrong behaviour...
2011-07-01 jow[ar71xx] turn status LED off if device finished initial...
2011-06-30 juhosgar71xx: remove CONFIG_MTD_CONCAT ifdefs from the WZR...
2011-06-29 juhosgar71xx: merge 2.6.39 patches
2011-06-29 juhosgar71xx: remove 2.6.37 support as well
2011-06-29 juhosgar71xx: remove 2.6.38 support
2011-06-29 juhosgar71xx: switch to 2.6.39
2011-06-29 juhosgar71xx: add 2.6.39 support
2011-06-29 juhosgar71xx: remove ar71xx_gpio_irq_set_type
2011-06-29 juhosgar71xx: add separate handlers for IP3 interrupts
2011-06-29 juhosgar71xx: use separate handlers for IP2 interrupts
2011-06-29 juhosgar71xx: remove useless irq_desc.status initializations
2011-06-25 nbdar71xx: add default network config for wzr-hp-ag300h...
2011-06-25 nbdar71xx: bring up secondary radio on wzr-hp-ag300h ...
2011-06-19 juhosgar71xx: cleanup AR933X UART driver
2011-06-19 juhosgar71xx: fix uart clock frequency for AR933X
2011-06-13 juhosgar71xx: use ar933x_uart.h in the AR933X serial driver
2011-06-13 juhosgar71xx: update early_printk code
2011-06-09 acinonyx[ar71xx] Remove trailing spaces, convert spaces to...
2011-06-07 nbdar71xx: override inittab to enable login on ttyATH0
2011-06-04 juhosgar71xx: setup wdt_clock for AR913X to avoid a kernel bug
2011-06-04 juhosgar71xx: select the internal antenna by default on the...
2011-06-01 nbdRevert "ar71xx: only enable the rx engine after the...
2011-06-01 juhosgar71xx: init external_reset for AR933X
2011-06-01 juhosgar71xx: add external_reset field to ath9k_platform_data
2011-06-01 juhosgar71xx: init get_mac_revision on AR9330 rev 1
2011-06-01 juhosgar71xx: add get_mac_revision to ath9k_platform_data
2011-06-01 juhosgar71xx: export SoC revision
2011-06-01 nbdar71xx: add profile and image building code for wzr...
2011-06-01 nbdar71xx: add kernel support for the buffalo wzr-hp-ag300h
2011-05-31 juhosgar71xx: build images for the AP121 boards
2011-05-31 juhosgar71xx: add sysupgrade support for the AP121 boards
2011-05-31 juhosgar71xx: add default network config for the AP121 boards
2011-05-31 juhosgar71xx: add support for the AP121/AP121-MINI reference...
2011-05-31 juhosgar71xx: register UART for the AR933X SoCs
2011-05-31 juhosgar71xx: add serial driver for the AR933X UART
2011-05-31 juhosgar71xx: add WMAC initialization code for the AR933X...
2011-05-31 juhosgar71xx: add ethernet initialization for the AR933X...
2011-05-31 juhosgar71xx: enable USB support for the AR933x SoCs
2011-05-31 juhosgar71xx: add AR933x specific glue for ar71xx_device...
2011-05-31 juhosgar71xx: the watchdog uses the reference clock on the...
2011-05-31 juhosgar71xx: add AR933x specific glue code for IRQ initializ...
2011-05-31 juhosgar71xx: don't register 8250 UART on the AR933x SoCs
2011-05-31 juhosgar71xx: enable GPIO support for the AR933x SoCs
2011-05-31 juhosgar71xx: add AR933x specific frequency initialization...
2011-05-31 juhosgar71xx: add AR933x specific early_printk support
2011-05-31 juhosgar71xx: add preliminary support for the Atheros AR933x...
2011-05-31 juhosgar71xx: stop producing -NA factory images and tag facto...
2011-05-31 juhosgar71xx: create factory images for the WZR-HP-G30{0...
2011-05-31 juhosgar71xx: Fix header offset for newer WRT160NL models
2011-05-31 juhosgar71xx: add SOC_AR{71XX,724X,913X,934X} config symbols
2011-05-31 juhosgar71xx: reduce the size of the squashfs-4k binaries
2011-05-31 juhosgar71xx: initialize is_clk_25mhz field for AR9340 WMAC
2011-05-31 juhosgar71xx: sync ath9k_platform_data.h with compat-wireless
2011-05-31 juhosgar71xx: use the diag LED for diagnostic on the WZR...
2011-05-31 juhosgar71xx: fix uci-defaults script for the WZR-HP-G30XNH...
2011-05-31 juhosgar71xx: ag71xx: make ring sizes configurable via ethtool
2011-05-31 juhosgar71xx: ag71xx: prepare to make ring sizes configurable
2011-05-31 juhosgar71xx: ag71xx: nuke unused AG71XX_TX_FIFO_LEN define
2011-05-30 nbdar71xx: only enable the rx engine after the link is...
2011-05-30 nbdar71xx: disable flow control for ar724x, it can get...
2011-05-17 matteoar71xx: don't probe the LAN PHY
2011-05-17 matteoar71xx: detect link on LAN ports
2011-05-14 matteoar71xx: add link detection on Ubiquiti devices WAN...
2011-05-14 matteouse correct macros and frame size in ag71xx
2011-05-14 matteoar71xx: cosmetic fixes
2011-05-08 juhosgar71xx: populate LED3 on the JA76PF board
2011-05-08 juhosgar71xx: add uci config for the WLAN LED on the WRT160NL
2011-05-08 juhosgar71xx: use phy0tpt trigger for the WLAN LEDs
2011-05-08 juhosgar71xx: remove superfluous fifo_cfg overrides
2011-05-08 juhosgar71xx: ag71xx: make switch register access atomic
2011-05-08 juhosgar71xx: ag71xx: fix section mismatch warnings
2011-05-08 juhosgar71xx: ag71xx: fix build error if debugfs is enabled
2011-05-07 juhosgar71xx: ag71xx: add debugfs entry for [rt]x_ring
next
This page took 0.069132 seconds and 7 git commands to generate.