RepRap%2FConfigs%2FSlic3r%2Fprinter.ini.mw

   1 # generated by Slic3r 1.2.9 on Thu Jan 28 20:04:50 2016
   2 bed_shape = 0x0,200x0,200x177,0x177
   3 before_layer_gcode =
   4 end_gcode = M104 S0        ; turn off temperature\nM140 S0        ; Bed off\nG28 X0           ; home X axis\nG0 Y177         ; moving Bed out\nM84               ; disable motors\n
   5 extruder_offset = 0x0
   6 gcode_flavor = reprap
   7 layer_gcode =
   8 nozzle_diameter = 0.5
   9 octoprint_apikey = 176444E92BFF48819CE0D8F1B264A91C
  10 octoprint_host = rapsberry:5000
  11 pressure_advance = 0
  12 retract_before_travel = 2
  13 retract_layer_change = 1
  14 retract_length = 5
  15 retract_length_toolchange = 10
  16 retract_lift = 0
  17 retract_restart_extra = 0
  18 retract_restart_extra_toolchange = 0
  19 retract_speed = 40
  20 start_gcode = G28 Z0            ; home Z\nG1 Z10         ; if bed is not level, don't scratch bed when homing XY\nG28 X0 Y0         ; home X Y\nG28 Z0
  21 toolchange_gcode =
  22 use_firmware_retraction = 0
  23 use_relative_e_distances = 0
  24 use_volumetric_e = 0
  25 vibration_limit = 0
  26 wipe = 0
  27 z_offset = 0